Butyl Cellosolve supplier Mumbai
Butyl Cellosolve exporter and supplier in Mumbai Maharastras, Gandhidham, Chennai, Visakhapatnam, Kolkata. Product details available on this link http://rxchemicals.com/product/butyl-cellosolve-acetate .
| Product Name | RXSOL-20-2099-210 |
| Product Type | Butyl Glycol |
Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA
Stock Point ::: Kolkata, Mumbai, Chennai, Visakhapatanm, Kandla, Fujairah
| Phone | +91 22 20871200 / 300 |
| Fax | +91 22 2781 1318 :::AOH :0091 9821214367 |
| mail@rxmarine.com | |
| Website | www.rxmarine.com |
|
Chemical Name |
CAS Number |
EC Number |
Index number |
|
Butyl Glycol |
111-76-2 2 |
203-905-0 |
603-014-00-0 |
Hazard description:
Information concerning particular hazards for human and environment:
R 20/21/22 Harmful by inhalation, in contact with skin and if swallowed.
R 36/38 Irritating to eyes and skin.
| General information | Symptoms of poisoning may even occur after several hours; therefore medical observation for at least 48 hours after the accident. |
|
After inhalation |
Supply fresh air. If required, provide artificial respiration. Keep patient warm. Consult doctor if symptoms persist.In case of unconsciousness place patient stably in side position for transportation. |
|
After skin contact |
Immediately wash with water and soap and rinse thoroughly. |
|
After eye contact |
Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor. |
|
After swallowing |
Call for a doctor immediately. |
Suitable extinguishing agents:
CO2, powder or water spray. Fight larger fires with water spray or alcohol resistant foam.
Protective equipment: Mouth respiratory protective device.
Person-related safety precautions: Not required.
Measures for environmental protection: Dilute with plenty of water. Do not allow to enter sewers/ surface or ground water.
Measures for cleaning/collecting: Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust). Dispose
contaminated material as waste according to item 13. Ensure adequate ventilation.
Handling:
Information for safe handling: Ensure good ventilation/exhaustion at the workplace.
Information about fire - and explosion protection: No special measures required.
Storage:
Requirements to be met by storerooms and receptacles: No special requirements.
Information about storage in one common storage facility: Not required.
Further information about storage conditions: Keep container tightly sealed.
Additional information about design of technical facilities: No further data; see item 7.
| Ingredients with limit values that require monitoring at the workplace: | |
| 111-76-2 2-butoxyethanol | |
|
PEL (USA)
REL (USA)
TLV (USA) |
240 mg/m³, 50 ppm Skin 24 mg/m³, 5 ppm Skin 97 mg/m³, 20 ppm Short-term value: 246 mg/m³, 50 ppm Long-term value: 98 mg/m³, 20 ppm Skin Short-term value: 50 ppm Long-term value: 25 ppm |
Additional information: The lists valid during the making were used as basis.
Personal protective equipment:
General protective and hygienic measures: Keep away from foodstuffs, beverages and feed. Immediately remove all soiled and contaminated clothing Wash hands before breaks and at the end of work. Avoid contact with the eyes and skin.
Respiratory protection: In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device.
Protection of hands:Protective gloves The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/ the chemical mixture. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation
Material of gloves: The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer.
Penetration time of glove material:
The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
Eye protection: Tightly sealed goggles
| Typical Physical Properties These properties are typical but do not constitute specifications. |
||
| Molecular weight (g/mol) | 118.2 | |
| Boiling point @ 760 mmHg, 1.01 bar | 340°F | 171°C |
| Flash point | 149°F | 65°C |
| Freezing point | -107°F | -77°C |
| Vapor pressure@ 20°C — extrapolated | 0.66 mmHg 0.89 mbar |
|
| Specific gravity (25/25°C) | 0.901 | |
| Density @ 20°C @ 25°C |
7.53 lb/gal 7.49 lb/gal |
0.902 g/cm³ 0.898 g/cm³ |
| Viscosity (cP or mPa•s @ 25°C) | 2.9 | |
| Surface tension (dynes/cm or mN/m @ 25°C) | 27.4 | |
| Specific heat (J/g/°C @ 25°C) | 2.38 | |
| Heat of vaporization (J/g) at normal boiling point | 348 | |
| Net heat of combustion (kJ/g) — predicted @ 25°C |
30.0 | |
| Autoignition temperature | 471°F | 224°C |
| Evaporation rate | n-butyl acetate = 1.0) (diethyl ether = 1.0) |
0.079 154 |
| Solubility, g/100 g @ 25°C Solvent in water Water in solvent |
||
| Hansen solubility parameters (J/cm³)1/2 _d (Dispersion) _p (Polar) _h (Hydrogen bonding) |
16.0 7.6 12.3 |
|
| Flammable limits (vol.% in air)Lower (measured @ 170°C) Upper (measured @ 180°C) | 1.13 10.60 |
|
Thermal decomposition / conditions to be avoided: No decomposition if used according to specifications.
Dangerous reactions No dangerous reactions known.
Dangerous decomposition products: No dangerous decomposition products known.
| Acute toxicity: | |||||
| LD/LC50 values relevant for classification: | |||||
|
Oral Dermal |
LD50 LC50 |
1480 mg/kg (rat) 400 mg/kg (rab) |
|||
| Primary irritant effect: | |||||
| on the skin | Irritant to skin and mucous membranes. | ||||
| on the eye | Irritating effect. | ||||
| Sensitization | No sensitizing effects known. | ||||
General notes: Water hazard class 1 (German Regulation) (Assessment by list): slightly hazardous for water
Do not allow undiluted product or large quantities of it to reach ground water, water course or sewage system.
Product:
Recommendation Must not be disposed together with household garbage. Do not allow product to reach sewage system.
Uncleaned packaging:
Recommendation: Disposal must be made according to official regulations.
Recommended cleansing agents: Water, if necessary together with cleansing agents.
Land transport ADR/RID (cross-border)
• ADR/RID class: -
Labelling according to EU guidelines:
The product has been classified and marked in accordance with EU Directives / Ordinance on Hazardous
Materials.
• Risk phrases:
20/21/22 Harmful by inhalation, in contact with skin and if swallowed.
36/38 Irritating to eyes and skin.
• Safety phrases:
2 Keep out of the reach of children.
36/37 Wear suitable protective clothing and gloves.
46 If swallowed, seek medical advice immediately and show this container or label.
This information is based on our present knowledge.However, this shall not constitute a guarantee for anys pecific product features and shall not
establish a legally valid contractual relationship.
- 1734 reads
RX MARINE INTERNATIONAL is most popular chemicals source in INDIA, Keeping ready stock at 5 LOCATION which includes Mumbai, Kandla - Gandhidham, Vizag - Visakhapatnam, Ennore - Chennai, Kolkata more then 3000 types of chemicals. Please click here to get PRODUCT Categories details http://rxmarine.com/Products
Mail Us for any PRODUCT related information and purchase inquiry : rxmarinechemical@gmail.com ( This mail is for customer / Buyer only ) And if you wants to add your hand as a supplier, And if you have volume manufacturing capacity of chemicals, pl. drop your mail at rxmarinechemical@gmail.com ( This mail is for supplier only )
