Membrane Antiscalant ALKA 191T
PermaTreat PC-191T, T-191 For Doosing Tank Fresh Water Maker Chemical, Kleen MCT 511
-
Membrane ALKA Clean RXSOL ORG-10 -
Antiscalant RO -
RO Antiscalant 2020 High Silica Inhibition -
Antiscalant ORG EV 2030 -
Potable Water Corrosion Inhibitor Pol -
RXSOL Altreat 400 -
Antiscalant RXSOL ORG EV -
Antiscalant Antifoulant Corrosion Inhibitor 704 -
DODECYL SODIUM SULPHATE (DSS) -
ANTISCALANT 9209 RX Seawater Distillation Plants
PHYSICAL & CHEMICAL PROPERTIES
These properties are typical. Refer to the Material Safety Data Sheet (MSDS) SECTION 9, for the most current data.
| Color: | Clear, Yellow |
| Form: | Liquid |
| Odor: | Slight ammonia smell |
| Density: | 11.33 lb/gal |
| Specific Gravity @ 25oC (77oF): | 1.36 |
| pH (Neat): | 10.5 |
| Freeze-Thaw Recovery: | Complete |
| Viscosity @ 25oC (77oF): | 20 cp |
| Flash Point (PMCC): | None |
| Solubility in Water: | Complete |
| Freeze Point: | 32oF (0oC) |
| Volatile Organic Compounds (VOC): | 0% |
RO antiscant
Scaling is caused in membranes because the level of hardness salts in the water becomes highly concentrated as it passes through the RO unit. In smaller units scale formation can be prevented by base exchange softening the make-up water but for larger systems that is very expensive. We have developed a range of easy to handle, cost effective RO Antiscalant which increase the solubility of the hardness salts so they remain in solution rather than forming scale on the membrane. Our cost effective RO antiscalants will inhibit a wide range of foulants including: calcium carbonate, calcium sulphate, barium sulphate, strontium sulphate, calcium fluoride, silica and iron.
RO Antiscalants are dosed directly to the RO feed water tank or feed water line (after pretreatment) at the recommended dosage of 1-3 mg/L and maximum dosage at 8mg/L, subject to inlet water quality and parameters is respect of Calcium Hardness, Iron, TDS, Alkalinity, pH and silica content. Maximum dilution should be 10% with RO or DI water for temperature less than 30 deg C. For higher temperature the dilution ratio can increase.
Key Features and Benefits
- Inhibit scale formation and effectively controls corrosion
- Protects the membrane efficiently
- Enhance the plant operation and equipments life span
- Economical
- Easy in usage and handling
It reduces the risk of scaling and eliminates the use of hazardous acids,resulting in efficient plant operation with highest possible conversion rate.
It is a very effective antiscalant . It is also compatible with RO CHEMICALS series of coagulant and flocculants (polyelectrolytes). Our RO Antiscalant (HIGH PH) is effective in minimizing scaling in presence of foulants like Calcium Carbonate, Sulfate salts of Calcium, Barium, Strontium and Magnesium, Calcium Fluoride, Iron and Silica.
Key Features and Benefits
- Effective scale inhibition
- Alkalinity builder
- High recovery rate
- Low Chemical dosage
- Cost Effective
- Effective Iron fouling control by sequestration
- Reduced frequency of membrane cleaning
- Compatible with all types of membranes
- Completely organic and biodegradable
Application and Dosage
Our RO Antiscalant (HIGH PH) is dosed directly to the RO feed water tank or feed water line (after pretreatment) at the minimum recommended dosage of 1ppm and maximum dosage at 15ppm, subject to inlet water quality and parameters is respect of Calcium Hardness, Iron, TDS, Alkalinity, pH and silica content.
In case of high iron content of about 0.5 to 1.0ppm, the dosing has to be increased by 10-15ppm for stabilizing Calcium.
At about 10-15ppm dosage our RO Antiscalant (HIGH PH) is capable of fully inhibiting iron and calcium, and silica up to 166ppm. For higher silica content RXSOL ANTISCALANT should be used.
Antiscalant RO RXSOL-33-3302-025
Antiscalant C.I ALKA RXSOL-33-2034-025
Membrane Antiscalant ALKA 191T RXSOL-33-3321-030
Antiscalant ORG EV 2030 RXSOL-33-3325-230
Antiscalant RXSOL ORG EV RXSOL-33-3327
Scaling and iron fouling of the RO membranes will reduce system performance and lead to premature membrane replacement. Precipitation of scale and deposits build up on the RO membrane, which leads to poor permeate quality, low permeate production, unscheduled downtime, increased water consumption and increased energy costs.
Membrane Antiscalant ALKA 191T manufacturer, exporter and supplier in Navi Mumbai MIDC, Mumbai, Kolkata, Howrah, Tata, Ranchi, Munger, Patna, Varanshi, Chennai, Ennore, Visakhapatnam, Kakinada, Manglore, Goa, Mumbai, Surat, Gandhidham GIDC, Fujairah, Ajman, Deira, Sharjah, Dubai, Abu Dhabi Middle East - UAE, Oman Muscat
.jpg)
.jpg "Membrane Antiscalant ALKA 191T")
RX MARINE INTERNATIONAL is most popular chemicals source in INDIA, Keeping ready stock at 5 LOCATION which includes Mumbai, Kandla - Gandhidham, Vizag - Visakhapatnam, Ennore - Chennai, Kolkata more then 3000 types of chemicals. Please click here to get PRODUCT Categories details http://rxmarine.com/Products
Mail Us for any PRODUCT related information and purchase inquiry : rxmarinechemical@gmail.com ( This mail is for customer / Buyer only ) And if you wants to add your hand as a supplier, And if you have volume manufacturing capacity of chemicals, pl. drop your mail at rxmarinechemical@gmail.com ( This mail is for supplier only )
Get more with every purchase
Keep buying to get free reward points. For more details click at http://rxreward.com
