Product Dose

Information  are based on experience and are meant only as a guide since circumstances for each tank cleaning operation vary. They are not intended to interfere with the judgment of the vessel’s responsible personnel.Precleaning tanks with high pressure warm water is highly recommended since large deposits of oil or other residues in the tank must be removed to ensure an effective cleaning operation.

General Cleaning

For general use, dilute Holdbrite RXSOL  appropriately, depending on the contamination, and use conventional cleaning methods, such as brushing, scrubbing or hand spraying.

Removal of Soot from Inert Gas Systems (IGS)

Dilute from 5 to 20% of Holdbrite RXSOL in fresh water. Spray the solution onto the surface, using high pressure cleaning equipment. When used with a hand sprayer, apply 1 litre of neat Holdbtire Rx  per 12 m2. Allow the product to act and then rinse off with fresh water before drying. Allow solution to penetrate soil for about 30 minutes and then wash off thoroughly with high pressure fresh water, heated up to 80°C. Always wash off before chemicals dry on the surface. Repeat the procedure, if contamination persists.

Cargo  hold cleaning

For heavily soiled areas, a preliminary cleaning is required. If surface is heavily contaminated, higher concentrations of the product in water can be used. When used for spot cleaning, apply by hand spraying neat or prepare a 20% solution, and allow solution to penetrate soil for about 30 minutes before rinsing off with water. Always wash off before chemicals dry on the surface.

Heavy Soil deposition                    Use Undiluted from to 20-50% diluted with water. 
Medium soil deposition                 10-20%  diluted with water. 
Light Soil ( general degreasing )   5-10% diluted with water.

Tank  cleaning

Holdbrite RX  is ideal for tank cleaning for most types of contamination. Suitable for epoxy, but not for zinc silicate coatings.The dosage rate for direct injection with tank washing machines is 1-20 litres per ton wash water (0.1-2.0%). For recirculation, use a rate of 1-20 litres per ton wash water (0.1-2.0%). For heavily soiled areas, a preliminary cleaning is required.

If Slip Barrier Coat RXSOL Hold Block or RXSOL Barrier Hold Coat is applied to the cargo hold surfaces prior to loading, the concentration of Holdbrite RXSOL  in the cleaning solution may be reduced.