Product Dose

PREPARATION: Make the solution of RXSOL ORG LOCO 20™ Locomotive Cleaner as low as 10%-30% volume  with water for high pressure, heated-rinse-water, automatic washing facilities or as high as 40%-50% for manual spray rinse operations. Temperatures of the cleaner and water should be at least maintain on room temperature as 20°c ; however, cleaning efficiency improves as the temperature of the water/cleaner is increased up to about 40 -50°c.

Apply The RXSOL ORG LOCO 20™ Locomotive Cleaner to a dry surface. Do not wet the surface to be cleaned with water prior to applying RXSOL ORG LOCO 20™Locomotive Cleaner.

PROCEDURE : Apply RXSOL ORG LOCO 20™Locomotive Cleaner with a low-pressure sprayer with a fan-type nozzle in an even, back-and-forth, horizontal motion, starting at the bottom and moving up. It is usually best to apply Locomotive Cleaner to 1/4-1/3 of a side at a time prior to rinsing. However, with a very thorough, even application, an entire side can be done in one application

DWELL TIME: Allow RXSOL ORG LOCO 20™Locomotive Cleaner to remain on the surface of the locomotive for at least 3-5 minutes prior to rinsing off a section.

RINSE: Rinse the locomotive surface with high-pressure water from pressure washing equipment at, at least 2000psig at the spray nozzle. Hot water improves both the cleaning and rinsing effectiveness, but is not a requirement. Use a fan or wedge type sprayer nozzle and rinse from the top down in even, horizontal back-and-forth motions to avoid vertical streaking.

FINISH: Capture and treat the run-off from the locomotive cleaning operation, if required by local, state or federal regulations, or company policy.