Power Plant / Heavy Industries-37

Can cause severe burns to skin, eyes, and internal organs.

For industrial use only by trained personnel. Will etch glass. Avoid contact with skin, eyes, and clothing. Do not take internally.

Protective clothing such as goggles, face mask, rain suit, and rubber gloves must be worn. Check gloves to insure no pinholes are present. Contact with diluted material cleaner may not cause immediate pain, redness, or burning until several minutes have elapsed.

Truck Wash Brightner Cleaner manufacturer and supplier in Mumbai, Nashik, Pune, Kandla, Gandhidham, Surat, Kolkata, Vishakhapatnam, Chennai, Fujairah Sharjah Abu Dhabi Dubai, Muscat Barka Ruwi OMAN, Kenya Nairobi AFRICA, Canada, Sudan, Yemen AFRICA

#TruckWashBrightener_Muscat
#TruckWashBrightener_Dubai
#TruckWashBrightener_Mumbai
#TruckWashBrightener_Nairobi

Rust Remover Powder manufacturer and supplier in Mumbai, Kandla Surat, Chennai, Visakhapatnam, Kolkata, Varanashi, Ruwi Ghala, Muscat Barka, Oman, Fujairah, Dubai, Sharjah, Ajman, Abudhabi, UAE, Sudan, Yemen, Nairobi, Kenya, Canada

USES:

Deep cleaning of outdoor condenser coils to restore efficiency and increase performance of the system.

DILUTION RATIOS:

Because RXSOL-41-8672-025 is highly concentrated, it must be diluted prior to use. Dilution also improves penetration into the coil and increases product performance. Actual dilution ratios will vary according to the application. The following is intended as a general
guideline:

• Up to 8-10 parts water to 1 part  RXSOL-41-8672-025 coil cleaner  for light cleaning and brightening, when expanding foam is not required.
• 3-5 parts water to 1 part RXSOL-41-8672-025 coil cleaner on difficult cleaning tasks.
• 1-2 parts water to 1 part RXSOL-41-8672-025 coil cleaner  for use as a high foaming,aluminum finned, air cooled condenser coil cleaner.Use the minimum concentration required to accomplish your task.

Note: Do not use RXSOL-41-8672-025 coil cleaner at concentrations greater than 1:1 (less than 1 part water to 1 part RXSOL-41-8672-025 coil cleaner. Rinse the treated surfaces as well as the surrounding area thoroughly after use.

APPLICATION METHODS:

Low pressure, acid resistant tank sprayers are recommended.
Regardless of application method, avoid inhalation of mist or contact of liquid or mist with skin.

SUGGESTED INSTRUCTIONS FOR USE:

•  When handling RXSOL-41-8672-025 coil cleaner or any other strong chemical, be sure to wear chemical imperviousgloves,apron and splash goggles.
   
• Determine required dilution ratio for the specific application. It is recommended to start with a dilution ratio of 10:1 and increase concentration until the desired results are achieved.
   
• As with mixing all acids, place the desired amount of water into the tank and then add RXSOL-41-8672-025 coil cleaner
   
•  Turn off fans and allow hot coils to cool before applying.
   
• Using plain water, wet both the condenser coil as well as the area surrounding the equipment. Wetting the coil with water aids in product penetration and performance.
   
• Apply the properly diluted product to the coil surface. Whenever possible, apply solution from the outlet side of the coil. Allow product to remain on surface, normally 5-10 minutes. Do not allow product to dry on the coil. Note: In extreme cases, application may have to be repeated to achieve desired results.
• If foaming does not occur, check for extreme grease buildup which will slow cleaning process. Foaming may not occur if coil is coated or painted.
   
•   Rinse coils, tools and surrounding area thoroughly after completing the coil cleaning process

Coil Cleaner manufacturer, exporter and supplier in Dubai, Muscat, Sharjah, Sohar, Abudhabi, Ajman, Barka Oman, UAE Middel East and in India, Mumbai, Surat, Kolkata, Chennai, Ranchi, Tata Jamshedpur, Dhanbad, Varanashi, UP BIHAR, Canada, Nairobi Kenya Africa, Canada

PRODUCT PROPERTIES :

Descalex SafeAcid Powder supplier in Mumbai, Kandla, Kolkata, Visakhapatnam, Chennai, Fujairah, Muscat, Nairobi Kenya, Surat Gandhidham, Gujrat, Ajman, Dubai, Abudhabi, Dubai, Sharjah UAE Middle East, Muscat Sohar Barka Oman, Yemen, Sudan, Nairobi Kenya Africa

- Appearance: Liquid, viscous, colourless, soluble in water

- pH <1.5 at 1 % concentration

- Boiling point - not known

- Vapour pressure <0.01 kPa at 20 deg C

- Vapour density - not known

- Freezing point <0 °C at 760 mm/Hg

- Completely soluble in water

Helps to clean Stainless Steel Castings & Welded Components.

RX JELLY Pickling Paste having multiple utility, Its multi directional uses have 8 products properties as follows:

1. Degreasing Action as METAL SURFACE CLEANER – Removes light mill oil and water based cutting fluid

2. RUST Cleaner as RUST REMOVER – Removes surface rust completely

3. Corrosion Inhibitor as RUST INHIBITOR – Provides years of indoor Rust Protection (more than 6 to 8 years).

4. RUST CONVERTER – Converts 100% Rust and provide Protective coating

5. Clean Surface for WELDING PREPARATION as a ANTI-SPATTER

6. Works as PRE-TREATMENT and CONVERSION COATING – Prepares the metal surface for Priming, Painting, Electro-static painting, Powder Coating etc. Also can be used with High Temperature Paint & Coatings(operating temperature up to 2000⁰F)

7. Resisit further oxidation and acts as a SEALER  RX JELLY Pickling Paste coating seals by itself and stops further oxidation

8. RX JELLY Pickling Paste effectively acts as a DE-SCALER (MILL SCALE, HEAT SCALE)– One Step De-scaling/De-Rusting removes mill scale & rust, provide a conversion coating and Seal the coating.

RX JELLY Pickling Paste manufacturer and supplier in MUMBAI, Navi Mumbai MIDC, Taloja, Pune, Nashik, Surat Hazira, Gandhidham, Mundra, Sikka - Jamnagar, Chennai - Ennore, Goa, Kolkata, Haldia, Howrah, Visakhapatnam, Fujairah, Dubai, Sharjah, Ajman, Abudhabi UAE Middle East, Muscat, Barka, Oman